ttman4
Last Nite's Dream..
- Joined
- Oct 31, 2005
- Posts
- 1,095
- Reaction score
- 612
I'm trying to follow you guys, nearly got it figured out but not quite.
@1mouse3 & @IDIBRONCO you saying the AC Delco 60G & the Bosch 80034 are both for the GM 6.2 & 6.5 engines, correct? And both, are they self limiting plugs or not?
And they both have little bit narrower blades than the regular 6.9 bladed plugs? (Not recall the 6.9 plug number right now. I been running ZD9 in my 7.3......I have never had nor run a 6.9 before)
And @1mouse3 if i understand you turned some off the hex of 60G plug to get it to seat better/deeper? And maybe the Bosch 80034 might seat better than the 60G plug???
Other day I picked up set of AC Delco 60G plugs from ORiley. They are infact shorter than the ZD9 plugs, or at least shorter from the hex down to the tip. The actual tip is nearly same length, yet doesn't look to extend as deep into the head as the ZD9.
I feel I can run blade glow plugs on my 7.3 no trouble if they are self limiter plugs. I can either change bullet connectors over to blade connectors or make some short adaptors from bullet to blade.....no problem.
And Edit: When I Ohmn my plugs to check them what should be the good plug/ohm reading?
Just trying to get this all figured out. Thanks .
@1mouse3 & @IDIBRONCO you saying the AC Delco 60G & the Bosch 80034 are both for the GM 6.2 & 6.5 engines, correct? And both, are they self limiting plugs or not?
And they both have little bit narrower blades than the regular 6.9 bladed plugs? (Not recall the 6.9 plug number right now. I been running ZD9 in my 7.3......I have never had nor run a 6.9 before)
And @1mouse3 if i understand you turned some off the hex of 60G plug to get it to seat better/deeper? And maybe the Bosch 80034 might seat better than the 60G plug???
Other day I picked up set of AC Delco 60G plugs from ORiley. They are infact shorter than the ZD9 plugs, or at least shorter from the hex down to the tip. The actual tip is nearly same length, yet doesn't look to extend as deep into the head as the ZD9.
I feel I can run blade glow plugs on my 7.3 no trouble if they are self limiter plugs. I can either change bullet connectors over to blade connectors or make some short adaptors from bullet to blade.....no problem.
And Edit: When I Ohmn my plugs to check them what should be the good plug/ohm reading?
Just trying to get this all figured out. Thanks .
Last edited: