BeastMaster
Latest activity Postings About
-
-
Well I popped the PCM out and it seems like this blue square component is burnt up. Does anyone know what that component is, I can't for... -
This seems off to me. My ‘92 van doesn’t have a tach. But using an online calculator (crawlpedia.com) at 60 mph in OD with my 4.10 rear...
-
BeastMaster replied to the thread 1992 f250 abs light on and higher than usual rpm.Doesn't the VSS sensor feed both the speedometer and the ABS? Does the speedometer give steady readings? How easy is it to tap into...
-
BeastMaster reacted to IDIBRONCO's post in the thread 1992 f250 abs light on and higher than usual rpm with
Like.
Very important question. Assuming that it's a E4OD, whatever caused the ABS light to come on is also probably giving a bad signal to... -
BeastMaster replied to the thread Massive voltage drop when attempting to start; new batteries.Use rosin flux paste. You can get it at shops that deal in electrical work. Stay clear of anything marked "acid" or for plumbing. The...
-
I have an Auto Meter fuel pressure gauge. It's been working fine for me for the last few months.
-
BeastMaster replied to the thread E4OD OD light FIXED.Thanks for the write-up! There are very few places we can go to learn from those who have been up against these woes and conquered...
-
Fixing My "E4OD Overdrive Blinking Light" Issue First off, a big thank you to everyone who shared their experiences with the E4OD...
-
Your trans computer is not getting good power. It’s either a bad shorted wire or the trans relay. Mine used to do this exact thing...
-
BeastMaster replied to the thread Squealing Noise Until Operating Temp.Someone shared with me the act of holding the screwdriver ( or any other steel rod of appropriate length...3/8 extension rod, etc)...
-
I had no idea these things take oil. Note to self - check the oil level in mine.
-
Be sure to use Lock-Tite, especially the two bolts that bolt it to the Engine. Another great write up on VP`s. I have several I dragged...
-
Isspro makes excellent gauges and sensors
-
BeastMaster replied to the thread Vacuum pump tutorial.I appreciate you doing this. I know a lot of people consider this site as a haven for those seeking to keep our older machines working...
-
When I removed the oil level bolt from the old drive unit, it smelled like 80w/90. So did the emergency pump that I was running on the...
-
-
Loading…
-
Loading…
