-
-
DDirtyWood replied to the thread Unknown starting issue. Problem almost certainly lies with operator..If you crack the injection lines where they connect to the injectors you should get some wetness there but even with the engine running...
-
DDirtyWood replied to the thread Grease fitting on the pitman arm.Just wondering what axle are people having this problem with? My last two trucks have had kingpin D60s in front and I never had an issue...
-
DDirtyWood replied to the thread Unknown starting issue. Problem almost certainly lies with operator..If you're not getting any fuel out of the injection lines it is possible the injection pump is seized. Maybe someone more...
-
DDirtyWood replied to the thread TE06H Rebuild Banks Sidewinder 24010 TE06H.You can buy a re-seal kit from Banks for $20--just the rubber sealing components included when you buy a whole new turbo kit. I think it...
-
DDirtyWood replied to the thread TE06H Rebuild Banks Sidewinder 24010 TE06H.I am doing a different intake setup and would like to re-clock the compressor side--is the snap ring the only piece holding things in...
-
DDirtyWood replied to the thread Blown head gasket or cracked head???.At least in my area there is no shortage of cheap 7.3 IDI engines on FB Marketplace and often times you can get the whole truck for not...
-
DI never dynod mine after the intercooler, I’ve had it for a little over a month, but I run 12 max on a 7.3 with a banks aftertaste turbo...
-
DDirtyWood replied to the thread cx racing ebay intercooler.If you're limited to the 10-12psi that is considered safe with stock head bolts is there much of a power gain possible with adding an...
-
DDirtyWood reacted to Black dawg's post in the thread 7.3 idi turbo very very very long start with
Like.
My old worn out one starts the best in real cold on just the right amount of napa starting fluid, and glow plugs....lol. Not recomended... -
DDirtyWood reacted to IDIBRONCO's post in the thread 7.3 idi turbo very very very long start with Like.
As I pointed out earlier, the glow plugs have noting to do with the start, run a few seconds, and die issue. The long starter cranking...
-
DStarting fluid is fine in limited quantities and mostly in emergency situations. Over use can crack pre cups and break piston rings. As...
-
DDirtyWood replied to the thread 7.3 idi turbo very very very long start.You really didn't understand a word I wrote. Try again. " Starting Fluid/Ether in Diesel Engines with Glow Plugs Ether/starting fluid...
-
DDirtyWood replied to the thread 7.3 idi turbo very very very long start.A little starting fluid is fine IF the glow plugs are not being used as well--one or the other but not both. If your fuel system is...
-
DDirtyWood replied to the thread Smoke from injectors..I wouldn't recommend getting it "hot and sweaty".
-
DDirtyWood replied to the thread Rear Brakes on the 86 F-250, blew the R/R Hub Seal. Whada mess..Yeah we've had intermittent problems with the rodent population but leaving the hood up even partially will help. Better yet is to add...
-
-
Loading…
-
Loading…
