If you missed the previous posts, they are linked below:
Start Here
Second Update
Third Update
Fourth Update
Fifth Update
Sixth Update
Seventh Update
Eighth Update
I decided to move forward while waiting on the Moose pump and Moose injectors. I figured it'd be better to get the 6.9 back in the truck and install the Moose stuff when they get here. That way, I can continue working on the intercooler install as the parts should be here this week.
I went a head and installed the Banks wastegated turbo. I rewrapped the turbine inlet as the previous wrap was cut in a few placed during engine removal. The "how to" and complete photos are in the first rendition of this project HERE. Gotta install the glow plug harness and the throttle/cruise control cables at the time of the turbo install as those run under a heat shield behind the intake manifold and would be a huge PITA to do with the engine in the truck.
The South Bend Clutch SMF kit with a balanced flywheel (done with the rest of the rotating assembly) was installed. The bolts need 47 ft/lbs of torque and thread sealer. The flywheel and pressure plate were clean with BrakeKleen to remove any oil/residue. The 13 inch disk was installed under the pressure plate. The pressure plate bolts need 25 ft/lbs.
The engine was wrangled into the truck and the motor mounts bolted down.
Once the intercooler and Moose stuff get here, it should move right along. Will bolt the trans to the engine next weekend along with the US Gear underdrive and T-case. The I'll start getting the front clip back on and it's intercooler/York on-board air time.
Heath
Start Here
Second Update
Third Update
Fourth Update
Fifth Update
Sixth Update
Seventh Update
Eighth Update
I decided to move forward while waiting on the Moose pump and Moose injectors. I figured it'd be better to get the 6.9 back in the truck and install the Moose stuff when they get here. That way, I can continue working on the intercooler install as the parts should be here this week.
I went a head and installed the Banks wastegated turbo. I rewrapped the turbine inlet as the previous wrap was cut in a few placed during engine removal. The "how to" and complete photos are in the first rendition of this project HERE. Gotta install the glow plug harness and the throttle/cruise control cables at the time of the turbo install as those run under a heat shield behind the intake manifold and would be a huge PITA to do with the engine in the truck.
You must be registered for see images
You must be registered for see images
The South Bend Clutch SMF kit with a balanced flywheel (done with the rest of the rotating assembly) was installed. The bolts need 47 ft/lbs of torque and thread sealer. The flywheel and pressure plate were clean with BrakeKleen to remove any oil/residue. The 13 inch disk was installed under the pressure plate. The pressure plate bolts need 25 ft/lbs.
You must be registered for see images
The engine was wrangled into the truck and the motor mounts bolted down.
You must be registered for see images
Once the intercooler and Moose stuff get here, it should move right along. Will bolt the trans to the engine next weekend along with the US Gear underdrive and T-case. The I'll start getting the front clip back on and it's intercooler/York on-board air time.
Heath
Last edited: