-
-
parkergn replied to the thread Tachometer Troubleshooting.Great thanks @david85 yes I’ll have to try some more tests like you suggested to confirm if my tachometer is functioning properly... -
I looked briefly online at tach sensors for those engines and they seem to all be mag sensors. Not much shows up for alternator drive...
-
If you are handy at fabrication, it wouldn’t be too hard to make a custom clamp. I made two using 1/2” thick hard rubber pad and .060...
-
parkergn replied to the thread Tachometer Troubleshooting.Thanks for everyones input so far! Much to think about. @david85 - yes it should be for a diesel engine, however not sure if it's...
-
Jumping in with a coupla thoughts... @david85 , that was great input ! @ROCK HARVEY , I always appreciate your thoughts. @Kizer ...
-
The sensor may not be outputting a high enough voltage for this particular tachometer (0.15VAC does seem low). I wouldn't necessarily...
-
Been trying to hookup an aftermarket tachometer to my 6.9 E350 with C6. Don’t necessary need one, but thought it would be nice...
-
-
parkergn replied to the thread New age headlights.Depends on your headlights sizes. For my ‘86 with the 5x7. I went down this rabbit hole and ended up with Hella H4 Eurostyle housings...
-
-
I used an O'Reilly sold kit on my F250. On my RV, I just used o-rings I ordered as extras for the F250, bought the hose by the foot from...
-
parkergn replied to the thread ZD1A and ZD28 Glow Plugs from RA.All good! Just wouldn't mind the discount if its just a part number # ! Both BERU Germany plugs, same codes too?
-
I was wondering the same thing. Why the # change. Maybe they heat differently? IDK. Can`t assume. Don`t want to make an A S S outof U...
-
parkergn replied to the thread Arduino Glow-plug Controller, Build & Walk-through.Interesting idea! Following for updates. Will this be compatible for 6.9 too? Seems like this is a completely new system from scratch...
-
parkergn reacted to TheHappyHacker's post in the thread Arduino Glow-plug Controller, Build & Walk-through with
Like.
Thanks for the feedback, I know things look loose at the moment, but I addressed a few of these hurdles last night while designing the... -
parkergn replied to the thread ZD1A and ZD28 Glow Plugs from RA.Still wondering, are they the same glow plug? I can run both at the same time? Thanks!
-
parkergn replied to the thread ZD1A and ZD28 Glow Plugs from RA.Thinking of ordering a set of these ZD-28 plugs from RA. I still see 4 ZD-1 plugs for half-price. Think I could order 4 of ZD-1 and 4...
-
-
Loading…
-
Loading…
