X
XOLATEM
Latest activity Postings About
-
-
XI use that self stick foil insulation you can get from Lowe's. You will have to decide if you want to use the self stick, or they have...
-
XGo do a search on You Tube for "Transmission Bench" This guy has a full course on the E4OD where he does a full teardown and rebuild...
-
XXOLATEM replied to the thread E4od questions/trouble.I agree...the first hint of forward clutch distress was the shudder on acceleration. @trackspeeder knows what he is talking about...
-
XEither the forward clutch failed, or the feed bolts have backed out. Feed bolts can be re tightened. The clutch require rebuilding.
-
XThe original valve besides switching the plumbing for the fuel, does have the chore of electrically switching the sending units also...
-
XTube, small hose, large hose, rubber, plastic, even piece of siphoning hose, innertube, pieces of rubber tire, many things under hood &...
-
XMove the glow plug controller iff the back wall to the passenger fender. Inspect all the wires and repair as necessary.
-
XWhen you replace the throttle cable you could use a small section of 1/4 ID fuel line to protect the jacket from chafing. I have many...
-
XIt probably shorted against one or both of the power wires that go to the glow plug controller. That's why It was glowing red. That's...
-
XDisconnect the high idle plug see if it happens again, or follow the throttle cable to see if a wire is rubbing it.
-
XXOLATEM replied to the thread T-19 rebuild help.Isn't there two different thickness front bearings ? I ran into that when I built my T-19. I had gotten a new input shaft/main...
-
XWhat kind of driving cycle? Mostly highway? What RPM are you at? Mine burned that much fairly consistently. 1L per fillup, and yes it...
-
XWatch Rockauto flywheels. I've gotten two in a row that the balance was off. One of them was a 460/ZF5. Both were LUK flywheels, but I...
-
XXOLATEM reacted to IDIBOBS's post in the thread Truck is down. Fuel problem. Not sure where to start. with
Like.
you just have to slow down and think about things. Take the filter off. Crank it over. Do you have fuel? Yes? Problem is after lift... -
XXOLATEM replied to the thread Computer keeps throwing maf codes.If you had a borescope at that time and looked down the spark plug hole you would have seen that you had cleaned the combustion chamber...
-
-
Loading…
-
Loading…
