78loadstar
Registered User
Needed to put new rear caliper on my daily driver. Snow and cold so I turned on ignition on my 7.3 to take it out of gear to push it forward to get the back of my daily driver into the shop. No injectors in engine so I couldn't drive it forward. New injectors from moosebuddies coming this week, but I digress. Any way after I replaced caliper I went to push the 7.3 back where it was before I started. I then realized I left the ignition switch in the on position for the two hours I spent on the other truck. My question is did I screw anything up by leaving the switch on?
Dennis
Dennis