lotzagoodstuff
Latest activity Postings About
-
-
lotzagoodstuff reacted to jrez's post in the thread F350 80-86 Fuel Selector Valve Connector replacement with
Like.
I ran into the same issue on my OBS. Those old 6-port connectors are basically impossible to find. What I ended up doing (and what... -
lotzagoodstuff replied to the thread F350 80-86 Fuel Selector Valve Connector replacement.Is the wiring "one for one", just a different shaped plug? If you can identify the colors, might be worth cutting a harness off a...
-
She runs. 35psi oil pressure at cranking, idled it for about 15 seconds, no smoke after initial fire off. Ready to shove in.
-
I just switched my 97 f350 over to electric. I used a 6.0 pump assembly and mounted it in the frame between the engine and the tank...
-
lotzagoodstuff replied to the thread Intake Manifold Water Leak.Get out of Washington: everything should be better :)
-
lotzagoodstuff replied to the thread Portable Inflator suggestions.I bought a portable tank last summer and I can’t believe I lived this long without one. I think it might struggle with 35s at 60-70 psi.
-
Since you already have a (pancake) compressor.. why not just get a portable air tank? Most have a gauge and a short hose attached..
-
lotzagoodstuff replied to the thread The overly complicated disaster that is this swap project.First and foremost: As long as you are buying all that stuff pretty right, I see no issues. You can and will sell all that stuff as...
-
lotzagoodstuff replied to the thread 4WD IDI C6 are hard to find?.If you are really going to build a spare, you should think about an E4OD. I love old bulletproof stuff, but the lockup converter and...
-
lotzagoodstuff replied to the thread Swapping a 1995 engine, into a 1999 super duty.The 1995 F250350 has a different water pump/thermostat/heater spigot than all the later OBS years. If you haven't updated all that...
-
lotzagoodstuff replied to the thread Cheap Ebay lift.I put an add-a-leaf on my old red and white F250 and it did fix the front end sag, but I did have to install offset camber ball joint...
-
lotzagoodstuff reacted to DougBoy66's post in the thread So what did you do with your truck today? with Like.
Here is what they put in for us to use in cold weather. They keep the ol boys blood warm LOL It will help, it's zero degrees here this...
-
lotzagoodstuff reacted to DougBoy66's post in the thread So what did you do with your truck today? with Like.
Been traveling all around KC area Highways the last couple of put about 250 miles on it with the 4x4 locked in the whole time but the...
-
lotzagoodstuff replied to the thread 7.3 idi hard to start unless use starting fluid or block heater.Test each glow plug with a test light or measure impedance. By the way: what make of glow plugs did you install?
-
lotzagoodstuff reacted to Dirtleg's post in the thread 95 F350 Frame Swap to 96 F-Superduty. with Like.
Frame is painted. Hope it was warm enough to cure properly. We'll find out here in a while.
-
-
Loading…
-
Loading…
