R
riphip
Latest activity Postings About
-
-
RThat's not surprising. I couldn't quite see the number on the piston, but I think there's an above picture of cylinder #7 with the...
-
R"...too many visits from the ether bunny." "...this is how much an oil pan will dent if you knock the cherry picker over." LOL!
-
Rriphip replied to the thread Blew a head gasket, what parts am I gonna need?.Be sure to get some good silicone sealer for the oil pan, etc.
-
Rriphip reacted to The_Josh_Bear's post in the thread Blew a head gasket, what parts am I gonna need? with
Like.
If you ever tow or have over heating issues then do the 6.9 cooling mod. It's just putting a hole in the plug on the gasket corners to... -
Rriphip reacted to IDIoit's post in the thread Blew a head gasket, what parts am I gonna need? with Like.
you can try to create a basic comprehensive list for what you will need for a headgasket job. but the fact is, you will never compile an...
-
Rriphip reacted to WrenchWhore's post in the thread Source for new negative battery cables with Like.
I think I asked my local Napa if they do battery cables but they said no. They said they could crimp them though. I ask how do they...
-
RDoes your Wife sew? If so have her make one out of Nagahyde, then put the snaps or what ever on it and your done. I agree, Cardboard...
-
REvery winter I tear up a new cardboard for both the truck and the samurai. Toasty drives in the winter are the best.
-
RThat's what I did. I block off about 1/3 of the radiator and it does make a difference in heater output.
-
RWhy make it run hotter... +2 on only ford statt If ya need winter heat, block off some airflow
-
RBecause I know the general IDI design puts a lot of heat into the heads (and have dealt with overheated ones in the past) I'd be...
-
Rriphip replied to the thread IDI Shop in Tennessee for Head Gasket Job?.Been aware of it for past 20 years. Works for me after original head gasket blown. None after that!!
-
Rriphip replied to the thread 6.9 will not rev or idle right until return line is plugged.Did you replace the "olives" on all the hard lines?? Looks like they are leaking fuel. Also, get a new cowl gasket before you get water...
-
Rriphip replied to the thread IDI Shop in Tennessee for Head Gasket Job?.Get a 7lb radiator cap. You don't really need the 13lb cap & will lessen your engine coolant pressure. I personally use the #328 Stant...
-
Rriphip replied to the thread 7.3IDI piston scores?.Normal wear & tear. Scuff the cylinders with ball hone & new rings if not too out of round
-
-
Loading…
-
Loading…
