S
screwhead
Latest activity Postings About
-
-
SClogged fuel filter? Water in fuel (filling station at the bottom of a hill?)? Bad tank selector valve?
-
SIf anyway possible I’d highly recommend using a press to install the new seal I only had a 60% success rate with a block of wood and...
-
SMaybe something in this thread will be of help. https://www.oilburners.net/threads/rear-main-seal-questions.93119/ The Rotunda tools...
-
SYeah, you got this. Basically, all introduction threads start exactly like yours. I went through it and everyone else who bought their...
-
Sscrewhead reacted to WrenchWhore's post in the thread Dana 50 wheel bearing replacement, how in-depth should I get with
Like.
It's not that big a deal to pull the spindle and check the spindle bearings. Theres seal kits available online from Spicer. As long as... -
Sscrewhead reacted to Nero's post in the thread Dana 50 wheel bearing replacement, how in-depth should I get with Like.
If its the same truck in your Sig, I'd be more worried about checking the ball joints. You have to take the hubs off and knuckle assy to...
-
Sscrewhead replied to the thread Fel Pro Rear Main Wear Sleeve.Thank you all for the replies. My flywheel came with the new bolts with pre applied thread sealant, it leaked then and when I put lock...
-
-
SIf the crank has no visible sign of wear I wouldn't install a sleeve if it doesn't need it. Also, those rear crank bolts are drilled...
-
SWhen I typed the part number into Google, it only gave me the NAPA links. Not the Rock Auto one. I never do on a seal. I do between the...
-
SThat's not the only thing Google's been hiding over the years... :backoff LOL
-
SRockAuto sells that exact one in the "crankshaft seal" category. But then they also have a separate "crankshaft repair sleeve"...
-
Sscrewhead replied to the thread Fel Pro Rear Main Wear Sleeve.I decided to just take the sleeve out of the seal. It wasn’t as stuck in there as I thought, was probably just too worried about it...
-
SSo, according to Google, this is a NAPA only thing. I only got two links. Both to NAPA one in Canada, in French, the other in the States...
-
Sscrewhead replied to the thread Fel Pro Rear Main Wear Sleeve.I just don’t understand how that sleeve is going to go over the crank whenever seal is pressed into plate and then I attempt to install...
-
Sscrewhead replied to the thread Fel Pro Rear Main Wear Sleeve.To be clear on my other two seals they were installed as described above. Clean crank with no gasket maker or oil of any kind.
-
-
Loading…
-
Loading…
