bbjordan
Snow Monkey
the snout of the db2 is A bit under 2” and the 3208 is 4.75”, looking at how much would need to be bored out of the gear cover there’s enough surface area, but it would place the pump too high and it wouldn’t line up with the gear.
"It would place the pump too high" ... I'm not getting this part.
The 3208 pump shaft needs to be on the same axis as the DB2, yes? If this is the case, is there not enough room from the axis to the block for the pump? I think an adapter would be just the ticket to move the 3208 pump back into the valley, where hopefully, there is enough room for it.
Carry on with this most excellent project!