-
-
BBlack dawg replied to the thread How bad is the HG job on a 7.3 IDI?.The seals marked that way are refering to leaving the sealing lip dry. Like no oil. Silicone is for the od of the seal, if the bore...
-
BBlack dawg replied to the thread OD worth the $ ?.Still see them pretty regularly around here, used.
-
BBlack dawg replied to the thread OD worth the $ ?.Im sure you will get the results you are after at really light throttle and really flat ground. Add any load and it is pretty...
-
BBlack dawg replied to the thread How bad is the HG job on a 7.3 IDI?.Been a long time since I used that stuff, but always liked it back when we were using it a lot.
-
BBlack dawg replied to the thread How bad is the HG job on a 7.3 IDI?.Most likely same stuff as "ultra grey"
-
BBlack dawg replied to the thread How bad is the HG job on a 7.3 IDI?.Have used most all types over the years, but always ultra grey when it mattered. Lots of silicones seem to dry up over time, and get...
-
BBlack dawg replied to the thread How bad is the HG job on a 7.3 IDI?.With the engine out of the truck, and both surfaces clean and dry, ultra grey 100% of the time. With the engine still in the truck, I...
-
BBlack dawg replied to the thread Classic diesel designs reseal kit.I cant picture how that affects the corner cylinders vs the center cylinders?
-
BBlack dawg replied to the thread Classic diesel designs reseal kit.I always figured it was for cylinder wear. Cylinders at the corners of the engine always seem to wear more, because they are cooler...
-
BBlack dawg replied to the thread Classic diesel designs reseal kit.Looks like good gaskets and seals. Looks to be a pretty complete gasket set. The freeze plugs dont have to be removed if you dont want to.
-
BBlack dawg replied to the thread No Oil Pressure on 7.3 Idi.If you end up not having good pressure at the other port, put some air (with a rubber tip blowgun) to either one of the ports (with the...
-
BBlack dawg replied to the thread 7.3 Powerstroke swapped bricknose.Have any pictures? Maybe best to start over.
-
BBlack dawg replied to the thread Manual high idle troubles.Try it with the wire pulled from the cold advance solenoid.
-
BBlack dawg replied to the thread Intake Manifold Water Leak.loose bolts?
-
BBlack dawg replied to the thread The cooling upgrades work!.You did what you needed to to help out. But planning on pulling that load with the ram (single wheel even!) Is in my opinion dumb, and I...
-
-
Loading…
-
Loading…
