-
-
MThat’s awesome. I talked to a guy when I picked it up with a cool story. Supposedly his grandfather sold their old tractor to the farm...
-
Mmiked replied to the thread “The 6.9” project thread.My grandfather had a Farmall, but I am not sure what model, though it looked similar, and a massy 35 which was almost brand new at the...
-
Mmiked replied to the thread drive line angle.Sometimes it is just nice to go slow. The transmission mount and drive shafts that I used in my truck, came off a truck that had been...
-
Mmiked replied to the thread drive line angle.I thought I would update what I did with my drive line. I decided to check all my angles, starting with the engine as per chart above...
-
Mmiked reacted to KansasIDI's post in the thread Intermittent Start but runs good when it does with
Like.
To each their own Ether is a tool So is a large impact wrench Both can break things Both have specific uses Just my opinion, we can... -
Mmiked replied to the thread Engine ground washer.I have seen the star washer between the frame and cable. Thought it may be to bite into the frame to maintain better electrical contact
-
Mmiked replied to the thread drive line angle.I am sorry hear that happened to you while trying to help me out.
-
Mmiked replied to the thread drive line angle.Thanks u2slow your picture clued me in. I just checked my parts truck and that hanger bearing bracket is a good 2 inches deeper than...
-
Mmiked replied to the thread drive line angle.
-
-
Mmiked replied to the thread drive line angle.Found these specs. They are based off of the bottom of the frame rail just behind the cab. Looks like an angle change of .9 degrees at...
-
Mmiked replied to the thread drive line angle.
-
-
Mmiked replied to the thread drive line angle.Thanks all I suspended the hanger bearing by longer bolts, and a 2 1/4 inch gap gave me matching angles. This is the super cab, so maybe...
-
Mmiked replied to the thread drive line angle.5 degrees just seemed like too much. If it had been less than 2 degrees, I might have tried it as is. It is the size of the spacer I...
-
MHello I am converting from e4od to zf5 in my 1994 f250 idit short story. I have a 1990 cross member from a 1990 zf5 which would have...
-
M@snicklas I have forgotten about where the sig lines went, enlighten us please...
-
-
Loading…
-
Loading…
