And I got it installed.
You must be registered for see images attach
You must be registered for see images attach
I straightened it a little more in the grommet after I took the picture. It's way down in there and I couldn't see it well except the picture. This is so much better. I hope it doesn't leak for some stupid reason. It was not a fun job to get it all back together.
You must be registered for see images attach
Then I started hunting for my old crispy engine harness. Low and behold.
You must be registered for see images attach
On closer inspection. That's a metripak connector. 4 pin. A size smaller than 280 series I'm using on my relay boxes.
You must be registered for see images attach
I'll see if I can find one instead of trying to cut up and extract it from the harness and graft it in. Shouldn't be a problem. Probably the same size as my engine harness plug.
Then I started looking at my exhaust brake. It's military surplus for an mrap I believe. It's sized for a dt533. Can anyone tell me what kind of flanges it is. It's not a straight v- band. One side has kind of a cup, the other side a cone. It's a little over 4" to the outside of the flange.
You must be registered for see images attach
You must be registered for see images attach