-
-
Austin86250 replied to the thread Self regulating glow plugs.The Bosch ones for sale for these motors are self regulating, but I’ve never had issues with my manual glow plugs Like idi bronco says... -
Austin86250 replied to the thread Eccentric issues..Here’s to cams with the eccentric, spacer, hold down plate, and gear pressed off of course I don’t have A picture of the pressed parts
-
-
Austin86250 replied to the thread Eccentric issues..I was going though fuel pumps every2-5k miles on a bad eccentric new eccentric haven’t had an issue in 7k
-
Austin86250 replied to the thread Eccentric issues..Your phone camera is a lot easier than than the mirror method, this was the only picture I could find in my camera roll in a timely...
-
-
Austin86250 replied to the thread 7.3 idi swap for 7.3 turbostroke.U2slow brings up good point when comparing to an idi hard starting is invalid as the same argument for idis can be used just replace the...
-
Austin86250 replied to the thread circular base flange at end of exhaust?.Id love to hear actual science vs what I here in my small town
-
Austin86250 replied to the thread circular base flange at end of exhaust?.He is right, during a regen the exhaust coming out of the tip will melt plastic if it’s close, and can even light paper and bushes on...
-
Austin86250 replied to the thread So what did you do with your truck today?.Ohh I always thought you where Brian grilli this confirms it
-
Austin86250 replied to the thread Timing question.How did you go about that?
-
Austin86250 replied to the thread Timing question.I’m thinking there is an issue with the dti and or light itself
-
Credit: Harris John ford in facebook
-
-
Austin86250 replied to the thread Timing question.Meter was right I was another tooth off, it’s now close to 7* now Still want to know how to use the light
-
2 for one post here so bear with me According to my dti I’m -1* timing the reason I’m suspicious of this is that I don’t have any off...
-
-
Austin86250 replied to the thread So what did you do with your truck today?.Got some hood insulation, looks god aweful but it’s impressive on how much it helps Not bad for 6$
-
-
Austin86250 replied to the thread Return to center issues.While the bearing in my current column sucks, my old auto column as tight as a nuns k*nt and it had the same problem
-
-
Loading…
-
Loading…
