gregmiller185
Registered User
Hey new to the forum, hoping to use this to ask a few questions and share some pics of my project.
So I started with a 87 f250 5.0 with a 4 speed. And recently picked up a 92 7.3 with a banks sidewinder, E4OD and a trashed body. Both trucks 4x4.
I originally intended on swapping the motor/trans/tcase and axles to my 87 but then decided to just swap the 87 body and lift over to the 92 chassis. I am by no means building a show truck whatsoever, just something I can use and enjoy.
Here’s where I’m at.. I plan to use a baumann quick 4 to run the tranny but they are currently updating the displays or something? and looking at a couple weeks for that plus this virus is causing delays as well and not to mention the Canadian dollar has plummeted since I first talked with them. I’d be looking at 1500 Canadian by the time it’s to my door.
So I’m thinking of putting that on hold and wiring in the factory controller if possible. The harness i have is pretty chopped up but all the plug ends are there and I’ve found the wiring diagram for the E4OD which I will try to post.
What I need to know is if this is possible without using the 92 dash? And if so are there any circuits I do not need? I will pretty much be making my own harness.
Looking like I may have some time to play with this Or should I just fork out the cash and wait for the baumann?
E4OD wiring diagram: (hopefully that works)
http://askatech.com/AskATechLive/forums/ResourceHandler.ashx?a=7489
So I started with a 87 f250 5.0 with a 4 speed. And recently picked up a 92 7.3 with a banks sidewinder, E4OD and a trashed body. Both trucks 4x4.
I originally intended on swapping the motor/trans/tcase and axles to my 87 but then decided to just swap the 87 body and lift over to the 92 chassis. I am by no means building a show truck whatsoever, just something I can use and enjoy.
Here’s where I’m at.. I plan to use a baumann quick 4 to run the tranny but they are currently updating the displays or something? and looking at a couple weeks for that plus this virus is causing delays as well and not to mention the Canadian dollar has plummeted since I first talked with them. I’d be looking at 1500 Canadian by the time it’s to my door.
So I’m thinking of putting that on hold and wiring in the factory controller if possible. The harness i have is pretty chopped up but all the plug ends are there and I’ve found the wiring diagram for the E4OD which I will try to post.
What I need to know is if this is possible without using the 92 dash? And if so are there any circuits I do not need? I will pretty much be making my own harness.
Looking like I may have some time to play with this Or should I just fork out the cash and wait for the baumann?
E4OD wiring diagram: (hopefully that works)
http://askatech.com/AskATechLive/forums/ResourceHandler.ashx?a=7489