bulletpruf
Latest activity Postings About
-
-
bulletpruf reacted to IDIoit's post in the thread Can You Surface IDI Cylinder Heads with Sandpaper? with
Like.
ive also made plates to block off coolant passages to check the block for coolant leaks, and cavitation pin holes. my first IDI i... -
bulletpruf replied to the thread Can You Surface IDI Cylinder Heads with Sandpaper?.Just to clarify, Magnaflux is the manufacturer of the well known electric yoke used to magnetize metal parts that have been coated in...
-
bulletpruf reacted to IDIoit's post in the thread Can You Surface IDI Cylinder Heads with Sandpaper? with Like.
Magnaflux comes in cans, i use this stuff to check cracks on my products
-
bulletpruf replied to the thread 7.3 IDI Block Deck Flatness / Trueness Spec.My preference is no more than .001" per cylinder, so .004" for a V-8 cylinder head. If your block deck is perfectly flat, that helps.
-
bulletpruf reacted to IDIBRONCO's post in the thread 7.3 IDI Block Deck Flatness / Trueness Spec with Like.
I'm no machinist, but that sounds like A LOT of warpage to me. I might be wrong, but half that seems like a more realistic limit.
-
bulletpruf reacted to rreegg's post in the thread 7.3 IDI Block Deck Flatness / Trueness Spec with Like.
I have no experience with this but think there’s a recent thread about similar work from @bulletpruf It doesn’t have shop manual specs...
-
bulletpruf replied to the thread Can You Surface IDI Cylinder Heads with Sandpaper?.I've never had any luck popping out pre-cups.
-
bulletpruf reacted to FrozenMerc's post in the thread Can You Surface IDI Cylinder Heads with Sandpaper? with Like.
You can just pop the pre-cups out. Hell, most of the time, the darn things fall out as you pull the head away from the gasket....
-
bulletpruf replied to the thread Can You Surface IDI Cylinder Heads with Sandpaper?.Buy a lightly used yoke and some powder. I get a fair amount of use out of mine; used it last week to mag a block and heads...
-
-
bulletpruf reacted to WrenchWhore's post in the thread Can You Surface IDI Cylinder Heads with Sandpaper? with Like.
I'm always intrigued in these do it yourself at home methods. Just need to figure out a home brew magnaflux and you're in business.
-
bulletpruf replied to the thread Can You Surface IDI Cylinder Heads with Sandpaper?.No storage instructions, but it just sits on my stainless steel toolbox top. I did it dry. thanks
-
bulletpruf reacted to Clb's post in the thread Can You Surface IDI Cylinder Heads with Sandpaper? with Like.
Oooh really, sweet I like it. Do they give you storage instructions? Iv seen countertops stored against a wall bow. I can't see why...
-
bulletpruf replied to the thread Can You Surface IDI Cylinder Heads with Sandpaper?.It's a granite surface plate. Precision ground to .0001". Much flatter than glass or store bought granite. I tried to use thick plate...
-
bulletpruf reacted to Clb's post in the thread Can You Surface IDI Cylinder Heads with Sandpaper? with Like.
Sheet of glass and a towel on top of the granite,? Maybe? Did you mike the granite first? I've seen some less than stellar treatments in...
-
bulletpruf replied to the thread Can You Surface IDI Cylinder Heads with Sandpaper?.I was worried about the smaller size, too, but I couldn't find a large enough surface plate at a reasonable price. These are AMC V-8...
-
-
-
Loading…
-
Loading…
