Deezelcaddy
Full Access Member
As some of you may know from my concurrent thread about the ip, my truck has a dead hole in #1 cylinder. I have found a good junk yard motor and I will be doing the swap this weekend. I wanted to put out this thread to see if there were any tricks to yanking this monster. I have pulled my share of engines so I imagine it is pretty straight forward. My plan is to pull the rad and core support so I don't have to lift it too high. I will replace any leaky gaskets on the jy motor and do some upgrades on my way out: southbend 1
Piece flywheel/clutch, electric vac pump, carrier pump, new water pump and stat etc. I have a heavy duty 2
ton cherry picker so lifting it shouldn't be a problem. Thanx in advance for any advice/comments
Piece flywheel/clutch, electric vac pump, carrier pump, new water pump and stat etc. I have a heavy duty 2
ton cherry picker so lifting it shouldn't be a problem. Thanx in advance for any advice/comments