Baytonia
Full Access Member
Well Murphy is at it again.... What I thought would be a simple injector swap has stalled for 2 days. I am stuck and do not know where to go next. The copper washer stayed in the bore on 6 cylinders including the rear cylinders, hard to see and get down in there. I put solution in each cylinder to soak over night, tried to use a pic, rat tail file to no avail. They are smashed down real good. I was wondering if I could just put a new washer over top of the old one would it seal, also the injector tip would be raised in the cylinder what difference would that make with the spray? I thought about a spot weld drill bit, but afraid the copper so soft it would just chew through to the metal then I could never seal the cylinder, or worse the shavings go into the cylinder. Has this happen to anyone else?