typ4
Latest activity Postings About
-
-
typ4 replied to the thread Supply/Lift pumps.Which is why I assembled this. https://russrepair.com/priming-pump-and-filter-kit/ -
typ4 replied to the thread filter head return valve.I have fuel heater orings, if I find the bag ill post the number
-
typ4 replied to the thread Throttle cable melting.Get some of this, 1 inch size will protect the throttle and cruise cable. 92 up throttle cables wont work in early trucks, throw is...
-
typ4 replied to the thread Throttle cable melting.No the ATS didnt. The factory did
-
typ4 replied to the thread Gear Vendor output yoke?.Unless you're doing 25 miles an hour in reverse or more it's not even going to try to engage the gear vendors but I'm sure some people...
-
typ4 replied to the thread Carrier/facet pump observations.It's on a toggle switch on the four-wheel drive, it's key on the dually because I have it put a switch in to cut it off
-
typ4 replied to the thread Carrier/facet pump observations.I put this together specifically for priming, and it will get you there if the mech pump fails...
-
All the mechanical lift pumps I’ve seen have bleed ports built in as well. Apparently it’s to keep the fuel from running into the...
-
typ4 replied to the thread Hydraulic lifter orientation and wear patterns?.Its called a rocker fulcrum and they do wear, I anti friction coated my new ones 14 yrs ago and should have checked them when the valve...
-
typ4 replied to the thread Hydraulic lifter orientation and wear patterns?.The ATS 093 gets its oil from the block down by the oil filter. Not the sending unit location.
-
typ4 replied to the thread Gear Vendor output yoke?.Keep your existing driveshaft. Actually a very easy install. I am removing mine and going E4Od , if it breaks I can get one anywhere...
-
typ4 replied to the thread What am I Missing for WTS Hookup for a 7.3 Swap?.As you found out it is a ground switch. I hooked it to the CEL on my 88 which was a 460 truck, works perfectly.
-
typ4 replied to the thread Which fuel filter?.https://russrepair.com/6-9-fuel-filter-2-piece-min-order/
-
typ4 replied to the thread 7.3 IDI Turbo kit: ATS093 components w/ NEW CHRA, intercooler, Auber 2813, and more.Pretty sure that's not ball bearing it should just have the upgraded bushings. But in case it is whoever buys it can send me the...
-
typ4 replied to the thread Need a few Banks turbo pieces for an IDI.I'm pretty sure I have one or two maybe even three.
-
-
Loading…
-
Loading…
