Shawn MacAnanny
Full Access Member
I'm getting ready to install the water to air intercooler setup i've been working on this weekend along with the bull moose pump and misters plus remove the factory fuel filter. What is the best way to go about rotating the factory turbo to get the discharge to face upward? i see there are 4 bolts at the actual bearing or there are i think 6 or 8 bolts around where the waste gate actuator attaches. I am thinking i need to loosen the 4 bolts to rotate it and remove the 2 bolts that hold the waste gate actuator and move to the next available bolt set. Is that correct?