Kevin 007
Latest activity Postings About
-
-
Kevin 007 replied to the thread 7.3 IDI excessive oil usage.Im suspect that ether use at previous times in these engines lives could have broken rings to cause these problems, but maybe not the... -
Kevin 007 replied to the thread 7.3 IDI excessive oil usage.I see this from time to time when the CDR valve has been confirmed not the problem. Usually some broken or stuck oil control rings...
-
Kevin 007 replied to the thread 6.9 & 7.3 idi electric fan clutch conversion.Mine is working great. I no longer have to wait until it gets a little hot for comfort, before the factory clutch locks, IF it even...
-
Kevin 007 replied to the thread What's this in the oil pan?.Perhaps I should have said that it's not magnetized, instead of magnetic.
-
Kevin 007 replied to the thread 7.3 popping sound from intake no blow by clean oil.Could very well be a valve not seating correctly. It was pretty common on idi's, not so much on powerstrokes. but anything can...
-
Kevin 007 replied to the thread Oil Cooler - Bolt leak??.Probably the gasket. Using Hi-tack seems to be the best way to hold em in place and its good at holding a seal even after disturbing...
-
Kevin 007 replied to the thread What's this in the oil pan?.
-
Kevin 007 replied to the thread What's this in the oil pan?.It's ferrous, but doesn't appear to be magnetic. I will check that again to be sure
-
Kevin 007 replied to the thread What's this in the oil pan?.Ah! I bet you're right. The front cover was off of the engine years ago, so it would have been disturbed. I'll compare with a parts...
-
Kevin 007 replied to the thread What's this in the oil pan?.Just confirmed that it's smaller in diameter than the locating dowel for the IP drive
-
Kevin 007 replied to the thread What's this in the oil pan?.That's what I first thought
-
That almost looks like the locating dowell for the injection pump
-
Found in the bottom of the oil pan while doing an oil change. 92 E350, N/A, runs good. No noises. Lifter parts? The mech fuel pump...
-
-
Kevin 007 replied to the thread Could Someone Explain How These Valve Stem Seals Are Supposed to work.I don't run positives on the exhaust. Minimal oil consumption. These guides need all the lube they can get
-
My guess is because retarding the timing moves the combustion heat back, putting more heat into the exhaust and less into the piston...
-
-
Loading…
-
Loading…
