Search results

  1. M

    4x4 Conversion

    I’ve been looking for a new f250 and I found one that is a really good deal. But it is a 2 wd.. I have a boat I haul and really should have 4 wheels drive. It’s about 10k and a steep ramp that is heavy traffic and always wet. So I wouldn’t have to do it immediately but how awful would a 4 wheels...
  2. M

    FMV of f250 or f350 idi

    I sold my 93 f250 idi with a banks turbo maybe 2 years ago because it was just sitting with a locked up rotor and the frame was starting to rust and if it wasn’t addressed soon it would be a frame replacement and at the time I had zero time to do it... I’m looking to get another truck and...
  3. M

    F series 460 engines feedback

    I recently sold my 93 f250 7.3 idi. I had it for 15 years did a mild restoration maybe 10 years ago, new bed sides, fenders, paint etc.. looked nice on the outside but the frame was just about done from rust so I sold it since I also had almost 400k on it. So I am in the market for another...
  4. M

    Fuel oil in 7.3 idi

    I just got rid of my boiler in my house and have probably 40 gallons of heating oil left in the tank... Any issue with just putting this in my truck to get rid of it? 1993 Ford F-250 7.3 idi with a banks turbo kit
  5. M

    93 ford f250 7.3 4x4 transfer case linkage

    So after replacing all of my front ball joints, bearings, seals, and universal joints. Today the linkage that shifts it into 4x4 broke. I looked underneath and it was split in two where it mounts. Does anyone know where I can find one online or do I have to go to ford? My truck is a 93 ford f250...
  6. M

    Rebuilding front end 93 f250 dana 50

    I have a 93 f250 with a dana 50 in the front. I am replacing the ball joints and have them pressed into place and I have one problem. The passenger side axle was 2 pieces and I removed it at the slip joint under the boot. How do I remove the other section so I can replace the u joint? Is there a...
  7. M

    Buying the correct vacuum pump 7.3 idi

    Hi everyone, Since the autoparts store had many to choose from and non in stock I wanted to make sure I was buying the correct pump Has anyone tried the dorman Part Number: 904-807 and does it fit. I have a 93 ford f250 with a 7.3 idi originally a non turbo but I have the banks system...
  8. M

    Really hard break pedal 93 f250 7.3 idi

    So I have a 93 f250 7.3 idi. Over the winter I got an extremely hard break pedal. I figured it was just the booster since I saw the master cylinder leaking on it a little so I replaced both. I still had the hard pedal. Also my heating vents don't change until I get up in rpms driving and that is...
  9. M

    what kind of yoke to buy

    My truck is a 93 f250 regular cab, 7.3 idi originally non turbo, e40d auto trans, 4x4, and it has the dana 50 front axle, and the heavy duty rear end i beleive a sterling.. I need to buy a new yoke and wondering what yoke to buy and where to start looking, I don't have time to go to the junk...
  10. M

    universal joint broken

    So to start off the new Year on a good note, I broke my front universal joint on the side of the road this morning. I was able to buy one and get it home but I need to replace the yoke because it was damaged a bit, does anyone know how much they run, or where I can find one? Also the drivesahft...
  11. M

    oil leak...

    Okay so naturally now that I have just finished the paint and body work on my truck, the motor started leaking. It is a 93 7.3 idi with a e40d and banks turbo kit, the leak is coming from the back of the motor, and looks like it is running down the exhaust pipe in the center? Its hard to tell...
  12. M

    od light flashing

    I changed my injector pump today, and as soon as I got it running the od light started flashing, I have spedometer, and tach what could be the problem?
  13. M

    changed injector pump now flashing od L

    Okay so today I changed my injector pump, on my 93 f250 7.3 with e40d and banks turbo. Changing the pump went pretty smoothly but now I have a flashing od light, and it goes into lockup mode sometimes but not all the time, I already checked the tach sensor and its all okay and was replaced...
  14. M

    what size are injector lines?

    I am getting ready to buy a pulse adaptor and it comes with 1/4 inch adaptor, Is that the right size?
  15. M

    servicing front end of 4x4

    Okay so my 93 f250 regular cab long bed 7.3 with banks turbo, e40d, i have been kind of doing a driving restoration on. I started out just going to fix rust and a repaint but want to take care of some mechanical stuff at the same time. I have already replaced all the tie rods, drag link, and...
  16. M

    replacing axle seals in rear

    I am going to be replacing axle seals this weekend, I have the 3 inch wide shoes, I beleive that means I have a dana 70, is that right, what tool do i need to remove the hub? Is the tool the same for the dana 80? I was looking through the cornwell tool catalog and the only thing they has that...
  17. M

    where to buy fuel line and pump

    I want to replace the fuel line from the tank to motor, what kind of line and where do I buy? I have already replaced all the lines connecting the injectors when i replaced the injectors but need to replace the lines that go to the tanks.
  18. M

    replacing fuel tank sending units etc

    I had my bed off while doing some body work on my 93 f250 regular cab 7.3. I noticed that the front fuel tank sending unit was kind of getting a lot of rust, and I want to replace both sending units, and the fuel lines running to the front of motor next time I have the bed off in a few weeks...
  19. M

    getting ready to start paint and body pics

    Next weekend, I am going to start on the paint and body on my 93 f250 regular cab. I am a body/paint tech so its easy for me but wanted to see if anyone wanted pics with some instructions and such, it may be able to help someone whos just trying for the first time, I will be installing new...
  20. M

    spedo not working od light flashes

    so coming back from work last night my spedometer started to jump around and then my od light flashed accompanied by some very hard shifts? The tach was still working fine and have a new tach sensor on the 7.3 idi but where should I start looking for this problem? It does it sometimes and then...
  21. M

    what are people running as fuel these days

    I have never tried running anything else except diesel in my 93 7.3. I was just wondering what other people are doing, and hpw they prepare the substitute fuel and what needs to be done to the truck.
  22. M

    fabricating an intercooler

    okay so my 93 f250 regular cab 7.3 with and e40d and I just installed the banks side winder system on it. While I was at work working on a neon srt4 I had to replace the inter cooler because of a small scratch from the accident. I kept the old intercooler instead of tossing it in the scrap...
  23. M

    need some general specification info on turning

    Does anyone have a site that they can link that shows how much room it takes a 93 f250 regular cab long bed to make a u turn or a turn compared to another vehicle, any help here is greatly appreciatted and needed
  24. M

    installing brake controller need help fast

    I need to get my brake controller wired up in my 93 f250 as soon as possible. I found the plug under the dash, a 4 wire plug that has a red, blue, green, and white. What does what is what I need to know. Thanks Matt
  25. M

    installing brake controller

    Getting ready to install a brake controler in my 93 f250 today, Is there a plug for it or do I have to manually wire it in? Any help would be helpful

Latest posts

Forum statistics

Threads
91,288
Posts
1,129,821
Members
24,106
Latest member
lewisstevey7

Members online

Total: 795 (members: 12, guests: 783)

Share this page

Top