WrenchWhore
Latest activity Postings About
-
-
WrenchWhore reacted to NealP4334's post in the thread IDI return line caps - aluminum 6061! with
Like.
I found the exact same thing, although I didn’t put together that the inline ones were acceptable. I actually copied some Chinese ones... -
WrenchWhore replied to the thread Almost no braking power.If it makes you feel better you're not alone. I've already put in a new booster, master cylinder, and two vacuum pumps on my truck and...
-
WrenchWhore replied to the thread IDI return line caps - aluminum 6061!.I wouldn't recommend paint or powdercoat mainly because it can add unnecessary thickness to the I.D. of the part and possibly...
-
WrenchWhore reacted to XOLATEM's post in the thread IDI return line caps - aluminum 6061! with Like.
I am all about using metal instead of plastic. I also am all about having something machined instead of injection molded. I think that...
-
WrenchWhore replied to the thread Best/good source for mixed plastic hose return lines.When I couldn't come up with any good factory diesel fuel lines I ended up getting some decent fuel line off amazon and just replaced...
-
You need to tighten the alternator belt first, then the vac pump one. If you do it backwards, you won't have good results. Could be that...
-
WrenchWhore replied to the thread Delphi Return Line Kit From NAPA.I'm probably just overly cautious but I'd measure each new return cap with calipers, compare to the OE ones, and make sure they're sized...
-
WrenchWhore replied to the thread Delphi Return Line Kit From NAPA.Last time I installed a Delphi kit the straight caps were perfect but the turns were all (.010") oversized and leaked slowly. I ended...
-
DITTO ON THIS STATEMENT!!!!! DITTO x 10!!!!! Personally I think it might be kinda hard to do it but I think that about $10,500 or more...
-
WrenchWhore replied to the thread What she worth?.The KBB for a 1992 is about 3-4k which is total BS. I'd say post it for $9999.99 and see who bits. Don't be upset when people low ball...
-
The problem, for many states/regions that do emissions tests, is that they will see the VIN and say it's gas, and it'll fail emissions...
-
WrenchWhore replied to the thread Floor mats.I usually just get generic trim to fit black ones and cut them on the perforated lines until I get the fit I want.
-
Just remember, any water that gets under those rubber floors never leaves.
-
Good luck getting others on the internet to listen, especially those who aren't computer literate.
-
WrenchWhore replied to the thread First engine rebuild.My first question would be what's the full backstory on this engine you're starting to build? Year, displacement, engine health...
-
-
Loading…
-
Loading…
Latest posts
-
-
6.9 IDI E350 Van died while running, and no longer cranks- Latest: BeastMaster
-
-
-