Cruise:
Starting to feel that way, sheetmetal alone's gonna run me around $700 including shipping and Canadian peso exchange and that doesn't include all the little things(seam sealer, paint welding consumables etc)
Add that to the fact that I don't really know how to weld, own a welder that works or technically even have a place to do the work leaves me a bit screwed. Panel bond might work but again, going in blind.
I've seen cabs for 400-800 on occasion but they're few and far between especially extended.
IDIoit:
Rockers look ok but I'm finding the PO thought bondo was an attachment method so they're likely shot as well.
He just made the rocker door sill corners out of bondo so.
Anything IS possible with enough time money and skill, unfortunately I have very little of any of those.
Have about $1500 into it at this point, not sure I could even get that as it sits.
Also, rad supports pretty rusty, unsure how bad yet but looks like where the bottom hoop connects is gone. Found a rad support repair kit($500~) as nobody makes the diesel one with AC.
Gonna have to figure out what the best course of action is, as of right now it looks to be another too far gone project I own(up to 3 now
)
Hoping to get another update when it gets back above -10.