finally added some super tech tcw3 but think i added to much?????

[superbeetle73]

1/4 tank and added 16 ounces 2cycle anybody have any ideas

 

[jwalterus]

why worry about it?

it's new clean oil, you could run WMO, I don't worry about measuring tcw3, howes, or PS, I just dump it in when I fill the tank, sometimes it's one glug, sometimes it's a case of "I'll just finish off the bottle....", and once in a while, I actually measure

 

[6.9poweredscout]

i measure but usually overdose the howes at every fill up

 

[lotzagoodstuff]

You could run straight clean new 2 stroke oil and not hurt anything. Don't worry about a thing, drive it and add fuel as you burn it off if it makes you feel better, but you'll be fine as is.

 

[dakotajeep]

I would have used more...lol

Thad

 

[MIDNIGHT RIDER]

I have used 1-ounce/gallon TC-W3 for several years, precisely measured.

On another site, there is a guy that just about devoted his life to researching two-cycle oil in diesel as a pump lubricant.

He stated that 1-ounce/gallon was the best ratio and that is what I went with.

Also, for our purposes, Walmart Super-Tech rated highest in the lubricity tests.

Two cycle oil will also act as an anti-gel to a limited extent, plus it gets rid of moisture.

 

[freebird01]

i typically use half a qt of walmart 2cyl to a 19gal tank

 

[Kevin 007]

I used to use 16oz per tank no sweat! Till I discovered Bio-diesel....now I run B-5 all the time

 

[BioFarmer93]

Henry likes bacon drippin's and chicken fat stirred up together with a dash of Tabasco and some garlic... Other than that I do like Freebird with a pint of Wally 2-stroke per tank at fill up, unless I'm running WMO blend, then I don't worry about it.