MasterChiefIDI
Latest activity Postings About
-
-
MasterChiefIDI replied to the thread 7.3 IDI Bore or Sleeve?.Thanks Nero. That's reassuring. If I were to sleeve the rear two, I would also bore those to .030" so everything matches. -
My NA 7.3 idi for my mild turbo build seems it will need a .030" over bore to clean up. The block is rust free, pressure tested, and all...
-
MasterChiefIDI replied to the thread 7.3 IDI Mild Build going in a 1986 F350 thread.Also purchased the front half of a 1990 F350 w/ a Dana 60 king pin. Buying the frame with it is definitely the way to go as there are...
-
-
MasterChiefIDI replied to the thread 7.3 IDI Mild Build going in a 1986 F350 thread.Been working hard. Pulled the bed off and 6.9 out all in 8 hrs. That was moving pretty quick and a luckily having every needed tool to...
-
-
MasterChiefIDI replied to the thread Diesel timing adapter wanted.Obtained a Ferret 764. Thanks!
-
MasterChiefIDI replied to the thread 7.3 IDIT Turbo Exhaust Valves source.I may have asked too soon. Found them. Yes, IDIT valves were a different metallurgy (inconel) make up over the NA valves. My rebuilder...
-
MasterChiefIDI reacted to KansasIDI's post in the thread 7.3 IDIT Turbo Exhaust Valves source with
Like.
Call Justin at R&D, I’m sure he knows. -
MasterChiefIDI posted the thread 7.3 IDIT Turbo Exhaust Valves source in 6.9L IH & 7.3L IDI Diesels.I am looking for a source for 7.3 idit turbo exhaust valves. Does anyone have any leads or P/N? Building my NA heads back with turbo...
-
MasterChiefIDI replied to the thread Engine bay insulation.This is helpful. Thank you for sharing. I will take these tips and consideration when I do the interior. My main concern is insulating...
-
The things I did to quiet down my 86. Stripped the Interior and fully scrubbed and washed it out. Used one of the Harbor Freight air...
-
MasterChiefIDI replied to the thread Engine bay insulation.Thanks for all the input guys. I'm planning to use DEI's form a shield on the trans tunnel. May put some Kilmat underneath it though...
-
"Master Chief", sounds like you were is the Navy for a while. That nasty looking k rap as shown in your picture, I Removed it and gave...
-
You can buy the original molded stuff for the engine bay then do the foil dynamat / fake stuff on the inside. Be careful not to use...
-
I used killmat, cdd also does the same.
-
I use that self stick foil insulation you can get from Lowe's. You will have to decide if you want to use the self stick, or they have...
-
-
Loading…
-
Loading…
