I've been putting off installation of the temp gauge that I pulled from the RV that was on the hot line, installed in a tee that came with the kit, as shown below.
My understanding is the test port is an acceptable place to put a temperature sender on the E4OD, unlike C6. Is that true? And the port should be 1/8" npt?
But how deep is the port? Would the probe fit directly, which is 1/8" npt, or do I need an extension fitting so that it doesn't restrict flow?
My understanding is the test port is an acceptable place to put a temperature sender on the E4OD, unlike C6. Is that true? And the port should be 1/8" npt?
But how deep is the port? Would the probe fit directly, which is 1/8" npt, or do I need an extension fitting so that it doesn't restrict flow?
You must be registered for see images attach
You must be registered for see images attach
Last edited: