FordGuy100
Registered User
I'm going to attribute that to your poor timing, or pump. Like i said... watch my videos. I have NONE of these issues.
You are one of two guys who I've ever heard say good thing about his products though.
I'm going to attribute that to your poor timing, or pump. Like i said... watch my videos. I have NONE of these issues.
You are one of two guys who I've ever heard say good thing about his products though.
Although I disagree with two guys, because I spoke with more than that before I purchased. We'll go with two, and perhaps I am one of two guys that setup his products how he recommended, and did it correctly. I find that more plausible.
When I was messing with the timing on this thing... a single dimes width made the difference between it smoking nearly all of the time, and only smoking under WOT. The way I'm setup now I get no smoke at idle... barely any on a cold start, motor runs super smooth, no smoke under anything less than 3/4 throttle. So maybe I just got a magical set of Injectors and pump from him, or maybe I just have a healthy engine, and set it up right, who knows? But my videos don't lie.
I'm going to attribute that to your poor timing, or pump. Like i said... watch my videos. I have NONE of these issues.
If the guy likes his no fuel milage and ****** spraying injectors then that fine let him have them, but i dont want no part of it
Ok guys.....
let's take a deep breath and remember NO PERSONAL ATTACKS here.
NMB-
I'm glad to hear Ken is doing better and you're happy with the results of your purchase and installation. Only way to combat negative experiences is by doing good to your new customers and let them do the talking.
Dyoung-
everybody's input counts. even yours. but don't forget, like Ken, you have a reputation too.
everybody-
Ken is also a member here and he does check in now and then. I would have rather he made an attempt to explain himself in open forum, but he chose not to do so. Because he did go where no other IDI builder went before, his name is not posted in the "Hall of Shame" section due to his missteps. I'm enthused he's doing right to his new customers and he's letting them do the talking. That's the best advertising Ken can do.
you're a funny guy........... anyways, how do i get a reputation, and if i have one what kind is it?
Ok guys.....
let's take a deep breath and remember NO PERSONAL ATTACKS here.
NMB-
I'm glad to hear Ken is doing better and you're happy with the results of your purchase and installation. Only way to combat negative experiences is by doing good to your new customers and let them do the talking.
Dyoung-
everybody's input counts. even yours. but don't forget, like Ken, you have a reputation too.
everybody-
Ken is also a member here and he does check in now and then. I would have rather he made an attempt to explain himself in open forum, but he chose not to do so. Because he did go where no other IDI builder went before, his name is not posted in the "Hall of Shame" section due to his missteps. I'm enthused he's doing right to his new customers and he's letting them do the talking. That's the best advertising Ken can do.