Brian VT
Latest activity Postings About
-
-
Brian VT replied to the thread Normal oil pressures.I usually run Tractor Supply brand stuff as it's often the cheapest (and I've read tests on it being as good as any of them) but I... -
Brian VT replied to the thread Normal oil pressures.That gives me peace of mind that mine is normal. Thanks. And I won't stress too much if I see 60 on a cold truck again. But I'll try to...
-
Brian VT replied to the thread Normal oil pressures.I do usually use a block heater but only for a couple of hours before I'm going somewhere. When I know that I'm going somewhere...
-
I'm running 15-40 Delvac. Normal oil pressure at idle says @ 18. When I'm driving it's @ 40-45. It's winter here (just above freezing...
-
Brian VT replied to the thread 650cca vs 850cca group 65 battery.That's nuts. I changed the timing belt on my old Nissan Pathfinder. (well, I brought in help for the smart part) And the damned water...
-
Brian VT replied to the thread 650cca vs 850cca group 65 battery....and then there's battery heating pads.
-
Brian VT replied to the thread 650cca vs 850cca group 65 battery.Another option is if you have an Interstate Battery store near you. Ask for a "blemish". They usually keep them in the back. They have...
-
No question is dumb. ask away, that is how we learn. Your 85 Controller is the same way my 86 is. Reread how I wired it in post #6. I...
-
Brian VT replied to the thread 6.9 Glow Plug System problems.What intervals are best for the life of the glow plugs vs getting a clean burn going? I've been holding about 8 seconds (in winter) and...
-
Brian VT replied to the thread E4OD won't move from stop in D.I have no experience with the E4OD but I recently had to replace the neutral safety switch on my C6. Might be that? Easy fix (on the...
-
I'm sure everyone is on the edge of their seats waiting for a resolution. It was a bad marker light socket. The socket internally had...
-
Brian VT replied to the thread 7.3 idi knock.My air cleaner housing just has a hole in the bottom that fits over the outside of the intake. There's no bar across the hole on the...
-
Brian VT replied to the thread Revive old batteries?.I buy all my batteries from Interstate. I go to one of their stores and ask for the "blemished" ones. They're "in the back". They have...
-
Brian VT replied to the thread 7.3 idi knock.I'm confused. Sorry. They all had it when new but I may not be able to use it? I haven't noticed any modifications done to my intake or...
-
Brian VT replied to the thread 7.3 idi knock.I have the mesh with lid hold down nut. Do you know if the dome lid will work on my intake? (if I can find one, or make one)
-
-
Loading…
-
Loading…
