derjackistweg
Full Access Member
I just just on new 35s. As I did first right side front and rear I turned the truck on 265 left and 315 right side. After I parked the truck [3 times forward and back- this place was tight (at least for US cars)] the ABS light + Brake light came on.
Now it´s on 35 all around but still light on. I did not drive more than 20 yards still then but wither every start light are on. I needed to start several time to trim Fender and Bumper.
Truck is an Quigley Econoline 4x4 with an Dana 60 front and rear. 100k and an IDI N/A. It has rear ABS, not all around and it´s from 1993. As far as I now the truck has a limited slip in the back.
I liftet the truck with a standard simple and very small jack.
It is obvious that ~ 10% difference left and right is stress for the axle but this cannot result in a defect. Image slippery road or ice.
How can I clear codes? I have not jet checked codes. I´ll do this tomorrow.
Now it´s on 35 all around but still light on. I did not drive more than 20 yards still then but wither every start light are on. I needed to start several time to trim Fender and Bumper.
Truck is an Quigley Econoline 4x4 with an Dana 60 front and rear. 100k and an IDI N/A. It has rear ABS, not all around and it´s from 1993. As far as I now the truck has a limited slip in the back.
I liftet the truck with a standard simple and very small jack.
It is obvious that ~ 10% difference left and right is stress for the axle but this cannot result in a defect. Image slippery road or ice.
How can I clear codes? I have not jet checked codes. I´ll do this tomorrow.