Does any one know if there is a stock Garrett (or whoever) turbine housing that would fit the stock ATS 088 turbine wheel. I definitely have a 088 and not a 085 or 093 set up. I ask because I would like to weld on a T3 flange to the ATS up pipe to make turbo removal easier, not deal with leaking slip joints, and to use a tad bit small turbine housing for quicker spooling. I currently have 60-1 wheel and 60-1 compressor housing on the turbo.
Or could anyone suggest a replacement wheel/shaft and t3 turbine housing that would fit the 088 center section and compliment the 60-1 compressor set up?
I rebuilt the turbo and added the 60-1 compressor housing and wheel last summer so I don't want to get rid of the turbo yet. I actually do like the set up but was just trying to get a little sooner spooling.
Thank you in advance.
Or could anyone suggest a replacement wheel/shaft and t3 turbine housing that would fit the 088 center section and compliment the 60-1 compressor set up?
I rebuilt the turbo and added the 60-1 compressor housing and wheel last summer so I don't want to get rid of the turbo yet. I actually do like the set up but was just trying to get a little sooner spooling.
Thank you in advance.
Last edited: