I have had the fan belt on my 1992.5 F250 come off twice now. Both times it was on the 1.5 mile driveway that is very rough. Also both time had quite a bit of water around. What does everyone think time for a new adjuster? -cuss
92.5 7.3 with a ATS turbo. Bloody thing will not start. Turns over just fine but not start. If it was a cat or big diesel I would just see if it would fire on ether. But with glow plugs that is not good. Any idea before I start tearing into it??-cuss
I have 5 YO Batteries in my 92. It is getting to be time to replace them. I have looking at the Odessy, Optima and Diehard P2. Are these any good or should I go for the Standard batteries?
Ok now I have a new to me IDI with a problem.
The truck is a 1992 1/2 with serpintine belt 5 speed.
The problem is the ABS light keeps coming on and lately when I first drive the truck the brake pedal feels as if there is no boost until I go about 10 miles.
I have checked the...
I have a 6bt that I am putting in my 1990 ford F250. Now I bought the wrecked Dodge for $50. But I have a problem. I took the body off the truck so as to have access to the engine. I have started it without the turbo hooked up the intake just to try it out. it runs fine at a idle. Then I hooked...
Well it has been a rough winter with very rough roads. Now I have a problem with the fuel tank selector It does not switch tanks the fuel gauge reads full or works right some times. I am running on the front tank right now but have a full tanks in the rear.
Does anyone have wiring diagram...
I think this is a Blazer military rig. Does anyone have a wiring diagram? Looks to have 24 volt starter motor with a 12 volt selinoid. The problem is that the starter keep sticking on and burning wires or starters. This is the fire chiefs rig and we need to get it fixed.
Brake are realy hard to use. Transmission shift to hard. I think the vaccum pump is toast. Any Ideas of what else it could be?
I have been fording water for the last 4 days. It has been getting worse all 4 days.
What the problem seems to be is the fuel.
I go to start it will fire for a second then quit. After this I have to crank a lot to get it to fire. after it fires up semms to run fine. does not matter wether cold or hot. Just the amount of time setting.
I figure this is a air leak in the...
Many have read my posts on the 85 I have. Well I have a new to me set of hubs on the truck as of yesterday. The hubs came off a 68 1/2 ton Ford. The internals of these hubs make the one that were on it look wimpy. They seem to work fine but are hard to turn in. what I want to find is the wrench...
Does anyone know where a exploded parts diagram for a dana 44 in a 85 is?
I think I am missing a piece in one of my front hubs.
We pulled down the drivers side hub to day that was not locking. We found the wheel bearins loose. Tightened the bearings but it looks as if somthing is missing.
Well I got the 85 XLT 4X4. Now I begin the investigation into what is there and what I have to fix.
The tag on the door says:
GVW = F268
Trans = K
Axle = G2
Spring = 9GK
Can some one decde this for me please?
I wrote earlier about my head bolt problem. Well today we pulled the heads and this is what we found Any Ideas???? It looks like water was in at least 2 cylinders.
I have a slight problem. After my 7.3 destroyed itself I am getting ready to put in a 6.9 I have. BUT I have a problem this motor has been setting awhile. 4+ years in fact. The washers under some of the head bolts are cracked. Is it safe to use the motor aor should I pull the heads and put in...
After destroying my 7.3 I am going to replace it with a 6.9 that has been sitting for a while. But I have a couple of questions.
1. Can the 7.3 rockers be used in the 6.9?
2. Can the Valve covers be used from the 7.3?
3. Can the Exhaust maifolds be used from the 7.3?
I am going to...
was pulling out of the store in my 1990 f250 and the engine started knocking. I pushed the clutch in to coast it to the side of the road and the engine locked. I then went to restart and it is locked up. Checked the engine oil and it is 2x what it should be. it is not water this I can tell as is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.