david85
Full Access Member From Campbell River, B.C.
- Joined
- Last seen
- Viewing forum 6.9L IH & 7.3L IDI Diesels
Latest activity Postings About
-
-
Everyone like to junk the spring type clamps used from the factory but they are the best because they keep constant tension on the hose... -
david85 replied to the thread Cup holders.My mid 80s E24 didn’t even have cup holders. Instead, you had a cooler between the rear seats with a molded liner to secure 3 cans of...
-
I know autolite gets a bad rap sometimes but I have a manual push button system and have had great success with the autolite 1115 self...
-
david85 replied to the thread Self regulating glow plugs.I’ve been running the autolite 1115s as well for a couple years with no issues. I bench tested each of them for one minute before...
-
Well with most stuff being, ah, outsourced, to, uh, China, and what with them being able to make whatever quality you requested, and...
-
david85 replied to the thread Double Cardan Front Driveshaft Parts.I ended up just ordering a whole drive shaft. The old one was too far gone.
-
been wanting a e locker for several years now, And finally got around to it! made a short video about it as well
-
-
david85 replied to the thread e locker 10.25.Nice job! As I mentioned on the other thread, the factory bulkhead connector is probably not worth the trouble. Using a heat shrink on...
-
love it, just did the same on mine, and basically have seen all the things you have. the starboard was a nice touch!
-
david85 replied to the thread Factory Ford E-Locker Install.If I were to do it again, I’d probably just pass the wires through the gap for the gasket, with a couple of notches carved into the...
-
-
When I found it bad that morning, just before getting on the highway towards a bigger city in Colorado, from Laramie WY and having the...
-
david85 replied to the thread U-joint warning chime.I’ve been lucky so far. Never had a center support bearing fail. I wanted to swap in a single piece driveshaft but was told by one shop...
-
david85 replied to the thread U-joint warning chime.Hmm, for some reason the photos didn’t attach last night. Updated the OP.
-
For the last couple months I started having a clank sound from somewhere under the truck whenever I shift between forward and reverse...
-
-
-
Loading…
-
Loading…
