TPS and Transmission Range Sensor questions

[OLDBULL8]

When you changed the FILP, did you make sure the actuating fingers were placed like the pic below.

 

[FORDF250HDXLT]

did you remove it and re-install it while shifted in N?

 

[93yacht]

When you changed the FILP, did you make sure the actuating fingers were placed like the pic below.

I never changed it, I left the one that was on the pump that I swapped in, I just adjusted it to 1.2V...Funny you should ask that, I was thinking of pulling the TPS off of the old injector pump and swapping it onto the one in the truck now...I never had the OD off light flashing until I swapped injector pumps, but I was having the hard shifts...

did you remove it and re-install it while shifted in N?

Yes, I made sure that it was in neutral when I did it, and the lines were lined up correctly.

 

[trackspeeder]

The TPS could have dead spots. Check the full sweep with your meter. Any funky voltage jumps, replace the TPS.

 

[turbo elk]

So... What was the outcome on this? or did it jump through another thread?

 

[Selahdoor]

So... What was the outcome on this? or did it jump through another thread?

Inquiring minds want to know...