trackspeeder
Stone crusher. 58 From North Branford. CT
- Joined
- Last seen
- Viewing thread Holley Red are garbage, what else quickly?
Latest activity Postings About
-
-
trackspeeder replied to the thread Another E4OD flashing OD light thread.26 is TOT out of range. You get this code when the sensor goes bad. As for the filter, you can just toss it. It will not hurt... -
trackspeeder replied to the thread Another E4OD flashing OD light thread.It could be -10 you should not get that code unless there is something going wrong.
-
trackspeeder replied to the thread Another E4OD flashing OD light thread.Code 26 is a failed TOT sensor. Usually out of range. Pull the solenoid pack connector and check for fluid leakage. Most TOT failures...
-
front clip mounts done, engine pulled, spring buckets rough mounted. ill finalize them and get this thing on its own weight in the AM
-
trackspeeder replied to the thread Our beloved FL1995 oil filter is no longer cheap at Walmart.FL1995 is the old number. FL1995A is the current number. Same filter with an A at the end.
-
trackspeeder replied to the thread Another E4OD flashing OD light thread.Low fluid or low fluid pressure will lock the converter at low speeds. Check the fluid level. Check the alternator, your issues are...
-
trackspeeder replied to the thread Another E4OD flashing OD light thread.Next time the OD OFF light flashes, try pulling the codes. You should get something.
-
trackspeeder replied to the thread Trans Temp too cold?.99-00 Ford Superduty had the oil to water cooler eliminated to save cost. Ford warrantied alot of transmissions because of that move. 01...
-
trackspeeder replied to the thread Trans Temp too cold?.Ford developed the bypass valve to save the tranny from total failure do to blockage. Its pressure based, not thermal. What happens...
-
trackspeeder replied to the thread Trans Temp too cold?.The E4 will shift through all its gears hot or cold. To warm the fluid faster the TCM will prevent the converter clutch from locking.
-
trackspeeder replied to the thread Trans Temp too cold?.Run it the way it is. The temps are fine.
-
some solid progress! cab mounts 1/2 way done front axle needs spring buckets engine and trans is completely bolted down
-
Here's the canopy base plate getting prepped and drilled to fit. I'll get some more photos later to show the end result.
-
Leak tested it today. No water coming through at the bed rails but some of the windows will leak, if enough water overwhelms the tiny...
-
trackspeeder replied to the thread Another e4od wont shift to 3rd.Gap to the snap ring. 300 psi is good, so you have something else going on. Direct should be good.
-
-
Loading…
-
Loading…
