Wondering if this has been done before? My biggest concern issue would be if the V belt pulley will fit on the new SD pump shaft? I can get dimensiuon soff the new pump, coudl someone provide shaft dimensions off the old pump please?
running a SD PS pump instead of the old bricknose one?
- Thread starter Greg5OH
- Start date
IIRC it's just a C2 Ford pump, nothing special at all.
JM2CW
JM2CW
79jasper
Chickenhawk
Some of the van pumps were the good ones. Forget the pump name, same as the chevy's with hydro.
Easier to make fit a serpentine setup.
Sent from my SM-G900R4 using Tapatalk
Easier to make fit a serpentine setup.
Sent from my SM-G900R4 using Tapatalk
m885
Registered User
Do you mean Saginaw?
79jasper
Chickenhawk
Yeah, that. Lol
Was having a blank moment.
Sent from my SM-G900R4 using Tapatalk
Was having a blank moment.
Sent from my SM-G900R4 using Tapatalk
what riot means is they are the same pump.
innnteresting. I shall confirm this once i get my truck town down in next few weeks.
hmm, don thtink its a c2 pump..
thois is wha tmy new pump looks like
can someone get me the shaft diameter of the old idi pump please?
hmm, don thtink its a c2 pump..
thois is wha tmy new pump looks like
You must be registered for see images attach
can someone get me the shaft diameter of the old idi pump please?
didnt take the pulley off my SD pump, however i measured a new C2 pump, the shank diameter is .685
i was getting around .675 or so for the SD pump jsut using the vernier and eyeballing. So-most likely it is the same diameter.
I hope it is not smaller as that will make installing the V belt pulley more difficult and i would have to make some kind of sleeve.
i was getting around .675 or so for the SD pump jsut using the vernier and eyeballing. So-most likely it is the same diameter.
I hope it is not smaller as that will make installing the V belt pulley more difficult and i would have to make some kind of sleeve.
IHdieselfan
Registered User
That pump came off what ford
Negative Ghost Rider...not a C2...that's a NEWER SD pump k....be year specific next time *****
jaluhn83
Full Access Member
Might want to check the shaft with a metric caliper - I would not be too surprised if the idi pump is fractional inch (11/16" it looks like from your numbers) and the newer pump is a metric shaft.....
