Ok so I have been feeling with clutch master issues a lot with my truck, 3 cracked plastic ones cracked then I switched to the steel ones then was fine until I did a 5 speed swap and my firewall cracked, after that I installed a reinforcement plate, shortly after the pushrod bent and snapped at the threaded end. I have the heim joint mod on the other part. Anyway that was in august, well yesterday it snapped again and I have to order a new master because they obviously don't sell just the rod. So I plan on taking the new one to the machine shop and have a sleeve made for that section of the master. Anybody else deal with this before?