slideordie
Full Access Member
- Joined
- Jul 27, 2007
- Posts
- 55
- Reaction score
- 0
well i today i was adding a oil pressure gauge and temp gauge to the truck with a pillar pod. i went to remove the old oil sending unit pod and before i even get my wrench on it i notice its at an angle. to make a long story short theres a brass extension that the oil sending unit was on and it was already snapped and this explains the oil leak ive had and the lack of my oil pressure gauge working. so the problem is the threads from that brass extension are now in the block. i tried using an extractir to no avail. any suggestions?