Brick nose bumper mod

[mblaney]

Sorry bout that.
Tires are Firestone Deatination M/T's.

Thanks Gary.

Thanks - and I wasn't implying that you hijacked... I did that!

 

[ironworker40]

Thanks
Got the trim piece from rock auto. Cut the holes myself. Hardest part was making the template

I got my trim piece today. How did you cut the square holes for the square pins that snap into the bumper to hold it on?
If some had an old bumper they could take out the trim and trace out the 3 large holes and the pin holes on a piece of poster board, that would make it simple to layout.

 

[laserjock]

Do the holes have to be square? If so probably wouldn't be to hard to drill it out and then file the corners or dremmel them. I'm sure plastic tabs can tolerate a little radius.

 

[GENIUSLOERTS]

I drilled holes for the ends of each slot then used dremel to connect ends.

 

[tnthielen]

Thanks
Got the trim piece from rock auto. Cut the holes myself. Hardest part was making the template

Ordered my molding today. Thanks for the rockauto tip. 13 bucks shipped.

Gentlemen, do you happen to have a part number for these? I'm searching on RockAuto and I can't seem to stumble across them...

Thanks!

-Todd

 

[GENIUSLOERTS]

http://www.rockauto.com/catalog/raframecatalog.php?carcode=1126921&parttype=837

 

[tnthielen]

Thank you, sir! Ordered and on it's way!

You have a great looking bricknose, by the way!

-Todd