HammerDown
Latest activity Postings About
-
-
HammerDown replied to the thread Losing Prime.Final update... truck sat another week and fired up. Sooooo, the moral of my story is: even if you don't see damp/wet return lines but... -
HammerDown replied to the thread Losing Prime.I looked at the last time I purchased the return line kit from eBay and that was 2018. However, for some reason I don't believe it's...
-
HammerDown replied to the thread Losing Prime.Well, I only started the truck that one day and it didn't lose it's prime, been sitting again for a few days, I will use it tomorrow...
-
So the issue hasn’t persisted at all since the rebuild? With expansion and contraction due to seasons/temp I can definitely see this...
-
If this happens again in 2 to 3 years, I would suspect the material the o-rings in the kit are made from. I would then just get the...
-
Years ago, I read of a solution to an oil weep problem on an aero engine with a split case design (boxer engine). Oil leak was traced to...
-
HammerDown replied to the thread FSV (again!).Does the FSV have a dedicated fuse?
-
This is a diagram for a 1986 diesel. Fuse 15, 10 amp ok?
-
Blown fuse! So easy. Thanks for helping me think
-
There is no way the fuel can drain back from the engine, unless air is coming in at the engine somewhere. Think of it like a straw...
-
Have had some issues with extended cranking during cold starts last 6 months or so. Similar to @HammerDown engine will fire off for a...
-
HammerDown replied to the thread Losing Prime.UPDATE... Sunday the 19th I installed a new returned line kit. I started the truck and let it run for several minutes, it's been off...
-
HammerDown replied to the thread Cleaning out cruddy injector bores.Here's a thought ... using an air compressor with a good sealing tip blowing air into the GP hole while using the proper injector bore...
-
When I worked at the dealer back in the 80's and 90's I had a chunk of packing foam, the urethane stuff like they make knee pads and...
-
HammerDown replied to the thread Don't Ya Just Love....Some great replies/comments... working off a small step ladder I do fold-up a moving blanket with a piece of foam. As it was mentioned...
-
-
Loading…
-
Loading…
