ATS Turbo Questions

[IDIBRONCO]

As for the valley pan hole, one time I installed a reman engine in the shop I used to work at. Nothing I did would stop oil from leaking out around the pedestal/gasket at higher rpm's until I put a hole in the valley pan gasket there. I'm sure there was just something about the way it was built, but it was brand new. After that, I just got in the habit of punching that hole. I used a punch attachment on my air hammer. I always felt that it was better than drilling a hole-fewer shavings. Just be careful to not go too deep with the punch. It doesn't take a very big hole. Maybe 3/8 inch is all.

 

[67-7THREE]

another question, how can i tell if i have a 085 or 088 kit?

 

[67-7THREE]

where does the trans dipstick mount? looks like it will be in the way.

 

[bike-maker]

another question, how can i tell if i have a 085 or 088 kit?

As far as I can tell, they are pretty much the same with the exception of the air filter housing.
Square air filter = 088
Rectangular air filter = 085

 

[typ4]

The 088 has a giant casting with both exhaust passages in it.

 

[67-7THREE]

The 088 has a giant casting with both exhaust passages in it.

ok, so i have the 088 then. has the big exhaust housing with ats on it.

thanks!