J
JackJ217
Latest activity Postings About
-
-
JThat all depends on how the crank looks when you get the sleeve off. James
-
JJackJ217 replied to the thread Rear main seal question.That’s kinda what I was thinking. Would you remove the sleeve and use the seal I have, or would you recommend getting a new seal with a...
-
JStarted working on replacing my rear main seal while I have the trans out to swap it, only to realize after cleaning up the plate that...
-
-
JJackJ217 replied to the thread C6 to ZF5 swap.That’s exactly what I’m looking for. I have a 25 minute commute to work on the highway every morning and I hated revving this thing out...
-
JThe overdrive is wonderful. You can actually have a conversation with someone in the cab and listen to the radio when going down the...
-
JJackJ217 replied to the thread Core support fix???.Oops… I thought I had done that. Its an 87 F250 6.9
-
JI would say yes. I have saved the same piece from an old diesel support just in case.
-
JJackJ217 replied to the thread Core support fix???.Actually, I just found this about 2 hours from me. Could I just use the bottom hoop off a bullnose core support? Looks like it has the...
-
-
JTheoretically, if I were to buy a diesel core support for a 92-97 truck, would I be able to cut off the bottom hoop and the side...
-
-
JJackJ217 replied to the thread C6 to ZF5 swap.I was planning to put it on marketplace, but if he needs it he gets first dibs. I’m in Ohio halfway between cleveland and akron
-
JJackJ217 replied to the thread C6 to ZF5 swap.Definitely looking forward to not being at 3200 rpms going 70 mph just to barely keep up with traffic. Anywhere I go is at least 25...
-
JJackJ217 replied to the thread C6 to ZF5 swap.Gotcha. Thanks! One large step closer to getting this rig back on the road. I may need to solve the missing floor problem first though…
-
-
JJackJ217 replied to the thread C6 to ZF5 swap.Interesting. I had gathered that the c6 flexplate had a spacer from my research
-
JJackJ217 replied to the thread C6 to ZF5 swap.Pulled the trans out this evening :rock: I’m not seeing a flexplate spacer on the end of the crank??? There was an 1/8” thick ring...
-
-
JLooking to buy a clean rad support for an 87-91 diesel with A/C Located in ohio, will pay shipping if needed
-
-
Loading…
-
Loading…
