any one got a ZF5 4x4 tranny out for pics

[93turbo_animal]

Hi guys I would like a pic of the tail shaft of a 4x4 ZF5 I just need it for reference of the project I got comin up

 

[The Warden]

Does this help any?

I've got a few other pictures of the tranny, but I think these are the closest to what you're looking for...

Hope this helps some...good luck!

 

[93turbo_animal]

yep thats what I was wanting warden is that a locating pin in the pic I'm going to be getting an adapter machined and wonderd if anything stuck out the end besides the tail shaft thanks

 

[The Warden]

is that a locating pin in the pic

Yes, it is...to keep you from mounting the transfer case incorrectly.

 

[F350camper]

yep thats what I was wanting warden is that a locating pin in the pic I'm going to be getting an adapter machined and wonderd if anything stuck out the end besides the tail shaft thanks

Sounds like someone is gonna do some sort of an aux overdrive tranny. am I right?

 

[93turbo_animal]

Nothin gets by you Rob

Warden do you have any pics of the tranny side of the transfer case too and also would it be possible if you still got that tranny out to measure the inside diameter of the mounting flange Thanks

 

[sle2115]

Nothin gets by you Rob

Warden do you have any pics of the tranny side of the transfer case too and also would it be possible if you still got that tranny out to measure the inside diameter of the mounting flange Thanks

Whoa there partner! Putting an electric fuel pump on is a sin, but going with an overdrive or double overdrive is ok?

 

[Agnem]

That locating pin is dang handy. Makes the transfer case "hang on" while you take the last bolt out.

 

[93turbo_animal]

Whoa there partner! Putting an electric fuel pump on is a sin, but going with an overdrive or double overdrive is ok?

:draw you got that right more mechanical gears the better I'm trying to figure out now how to get rid of the electric shift motor and put in a lever so I can twin stick it :Sly

So I'm guessing that since the locating pin holds the transfer case up while taking the bolts out that the front of the transfer case is not machined to fit in the rear of the tranny for alignment

 

[The Warden]

do you have any pics of the tranny side of the transfer case too and also would it be possible if you still got that tranny out to measure the inside diameter of the mounting flange Thanks

I can't measure the inside diameter of the mounting flange on the ZF5; that tranny's been in my truck ever since last June. I still have the T-19 that came out of the truck, though, and can measure that (I'm pretty certain they're the same; the B-W 13-45 transfer case that was mounted to the T-19 bolted right up to the ZF).

I just looked; no pics of the transfer case that show the tranny side in any detail...sorry.

 

[93turbo_animal]

thats ok warden I've never had the tranny and transfer split so basically all I'm wondering is if the transfer has a machined lip that fits tightly in the rear end of the tranny for alignement

 

[The Warden]

I could be remembering wrong, but I believe there is a small lip on the transfer case.