Tomorrow, I am going to take my rear axle apart as far as I can without any special tools. Just the driver's side.
I want to have a look at what I am dealing with, before I begin to gather parts.
And that is also the reason for this thread. I need advice.
I believe it is a 10.25 rear end. Not positive. Where do I look for that info?
I believe this is "full floating", but I am not sure.
I believe full floating will mean it uses the gear lube for the axle bearings, and not grease on those.
And I need to know the correct socket for the spindle nut.
Can anyone help with that info?
As I said, tomorrow I will be under there with it. So I can look for tags, numbers, etc. And I will have it as far apart as I can, so I will know whether I am able to just pull the axle out, or whether it has a clip inside the diff.
Last, can anyone direct me to a parts diagram, and some way to figure out part numbers for the bearings and seals?
I want to have a look at what I am dealing with, before I begin to gather parts.
And that is also the reason for this thread. I need advice.
I believe it is a 10.25 rear end. Not positive. Where do I look for that info?
I believe this is "full floating", but I am not sure.
I believe full floating will mean it uses the gear lube for the axle bearings, and not grease on those.
And I need to know the correct socket for the spindle nut.
Can anyone help with that info?
As I said, tomorrow I will be under there with it. So I can look for tags, numbers, etc. And I will have it as far apart as I can, so I will know whether I am able to just pull the axle out, or whether it has a clip inside the diff.
Last, can anyone direct me to a parts diagram, and some way to figure out part numbers for the bearings and seals?