I used one of the metal bars that goes across the radiator to hold the wiring and left a bit of slack for engine movement.
Clip end to hold the electrical plug
You must be registered for see images attach
Wire hold down ties, little over kill
You must be registered for see images attach
Finished radiator support bar
You must be registered for see images attach
Wire ties bent over to hold the wiring
You must be registered for see images attach
And the electrical plug coming out the side of the fan shroud, for some reason I don’t have a pic of the actual fan shroud so I’ll get one tonight and post it so you guys have an idea where it comes out.
You must be registered for see images attach
I haven’t finished hooking it up to my temporary manual on/off switch to try it out yet, hoping to have that hooked up in the next few days.
The fan took a good 5 minutes or so to unlock after first start up which I’m guessing that’s because it’s been in every position for the last 2 months and not actually run, after a quick run around the block it was down to the lowest fan speed like it should be.
I’ll update more when I have the temporary wiring done and have full manual control of the fan.