IDI Diesel7.3
Ukrainian Power
I guess its more of a "solenoid pack", the one on the passenger side of the transmission, with the 9 pin connector.
But might have an idea... the wiring harness on the truck is from a 94' f-250 2 wheel drive factory turbo that had an e4od also (used the body and turbo from this truck), while the transmission harness is from a 93' f-250 4x4. I don't know if theres any difference in the transmission other than the output, but the wiring connectors between the tranmmission harness and the main harness don't match up. There is the larger connector which fits, but on the 94' harness there is a 4 pin connector, and on the 93' harness there is a 6 pin connector. I was going to just use the other harness but connector to the shift position sensor on drivers side of transmission is different. I just cut the trans connector and spliced on the 4 pin, and there was a Purple/Orange and Blue/Yellow wire left out... I had initially just thought that those wires were something for the transfer case, but maybe, maybe? From the diagrams I've seen the wire to "shift solenoid #2" on the 9 pin connector is a Purple/Orange wire, anybody know if thats the case? and if so, WHERE does that purple/orange wire go to on the 2wd main harness then if not to that connector?
But might have an idea... the wiring harness on the truck is from a 94' f-250 2 wheel drive factory turbo that had an e4od also (used the body and turbo from this truck), while the transmission harness is from a 93' f-250 4x4. I don't know if theres any difference in the transmission other than the output, but the wiring connectors between the tranmmission harness and the main harness don't match up. There is the larger connector which fits, but on the 94' harness there is a 4 pin connector, and on the 93' harness there is a 6 pin connector. I was going to just use the other harness but connector to the shift position sensor on drivers side of transmission is different. I just cut the trans connector and spliced on the 4 pin, and there was a Purple/Orange and Blue/Yellow wire left out... I had initially just thought that those wires were something for the transfer case, but maybe, maybe? From the diagrams I've seen the wire to "shift solenoid #2" on the 9 pin connector is a Purple/Orange wire, anybody know if thats the case? and if so, WHERE does that purple/orange wire go to on the 2wd main harness then if not to that connector?
You must be registered for see images attach