since we have 4 bolts that need to penetrate the engine mounting plates,
to install the engine, you effectively "stab" the engine into place.
to install the engine, you effectively "stab" the engine into place.
tick tick tick!!! ******
- Thread starter IDIoit
- Start date
The_Josh_Bear
Full Access Member
Ah I got it now...
I like your ground stand, too. At first I thought you'd cut the crossmember out in anger lol
Runningaford
Registered User
I guess it's too late, but perhaps you should've tried "Flex Seal".... I just saw a commercial where they welded an entire sandrail together!!!
Maybe you stop stabbing your engine, you may end up with less holes in the block
Got it together
Gotta watch the kids so my night got cut short
Down to fluids.
And an air cleaner
Gotta watch the kids so my night got cut short
Down to fluids.
And an air cleaner
You must be registered for see images attach
You must be registered for see images attach
Time for dzues fasteners and velcro???
i was able to squeeze some time in after the babies went to bed.
shes a runner now!
sounds a bit retarded, ill fix that tomorrow.
runs pretty good!
shes a runner now!
sounds a bit retarded, ill fix that tomorrow.
runs pretty good!
icanfixall
Official GMM hand model
Glad you got to hear it run after all that work. Still wonder why that rod broke too.
you and i both.
if i have the time ill break down the lower rotating assembly,
all i can say is that the rod had a hard life, even before me
i didnt get a chance to time it yesterday, but i did take it on a short trip to the store.
she feels good, just gotta get used to the clutch i have.
had to use a luk clutch that i had vs the PSD clutch i got from south bend.
the luk one is much softer.
but not even a drip of oil on the driveway this morning!
shes back in action!!!
she feels good, just gotta get used to the clutch i have.
had to use a luk clutch that i had vs the PSD clutch i got from south bend.
the luk one is much softer.
but not even a drip of oil on the driveway this morning!
shes back in action!!!
The_Josh_Bear
Full Access Member
Woohoo! Nice work!
Ac delete 
You’d be caught dead doing that in Texas
You’d be caught dead doing that in Texas
Delta ratz gotts "thee delta breeze"
yea its just too bad it wasnt the pot farms in Humboldt
this **** reeks lol
today was the first day ive seen clear skys in a few....
timed the truck today.
8.5 is where i like it.
truck feels solid again. only noticeable difference is im only boosting 6-7 instead of 7-8
gonna hit it with some soapy water tomorrow.
cant get used to the soft clutch.
need seat time.
but ill get it this weekend!
im taking her to the pot farms lol
yesterday when timing the engine, i had pulled off my intake to get to the #1 line.
while bringing the RPM's up to 2k to get a reading,
i noticed a oil leak, coming from the top of the engine.
was a pretty good leak too, which baffled me because it didnt leak previously.
put my intake tube back on and connected the CDR back up and not a single drop after i cleaned it.
looks like ill be pullin the turbo and putting holes in the valley pan.
while bringing the RPM's up to 2k to get a reading,
i noticed a oil leak, coming from the top of the engine.
was a pretty good leak too, which baffled me because it didnt leak previously.
put my intake tube back on and connected the CDR back up and not a single drop after i cleaned it.
looks like ill be pullin the turbo and putting holes in the valley pan.
