Oledirtypearl86
Full Access Member
Hey all looking for a bit of advice as what I've found online Isa bit vague fo what I want to get done in phase one for my newly acquired 82 bronco. So I got this bronco from the original owner it came out of San Antonio texas an has all the original paperwork and 30+years of service records the original owner told me it had like 203k miles on the clock but the records say 103k anyways after running it for aboit 200 miles I clocked 20mpg so that's good but got a slight top end tick I'm thinking lifter need adjusted any ways this is what I want to get done fairly quickly
1. Pull valve cover and adjust lifters
Anyone know what the aceptable tolerance is
2. Get the rear window to roll down all the way tight now it stops about 4 inches down
3. Check all the vitals/ oils an change a seal o .the transfer case the output for the front drive shaft pukes a little atf when ran in 4x4 I ran I to town an back today because it's snowing cats and dogs and seen about 6 or 10 drops of red in the snow
4. This is one that can wate but I'm curious about the removable top is fiberglass and has visible weathering and delamination is this repairable or look for a new
Any and all in puts appreciated as you guys have a lot more knowledge than me
1. Pull valve cover and adjust lifters
Anyone know what the aceptable tolerance is
2. Get the rear window to roll down all the way tight now it stops about 4 inches down
3. Check all the vitals/ oils an change a seal o .the transfer case the output for the front drive shaft pukes a little atf when ran in 4x4 I ran I to town an back today because it's snowing cats and dogs and seen about 6 or 10 drops of red in the snow
4. This is one that can wate but I'm curious about the removable top is fiberglass and has visible weathering and delamination is this repairable or look for a new
Any and all in puts appreciated as you guys have a lot more knowledge than me