Dear IDI'ers,
I'm swapping a 94 F350 IDIT into a 88 E350.
The PS pumps are different, and the newer motor is a serp. belt system. I was going to move the serp. pulley over to the old pump - as I have the correct PS lines for that pump and their length is for the '88 chassis. Unfortunately, the serp. pulley shaft diameter is smaller than the old pump shaft. The pressure line for the old PS pump isn't the same thread as the 94 PS pump (too small).
Should I just buy the 1994 F350 PS pressure line and not worry about the extra length? Is there a thread adaptor that is supposed to go into the PS pump housing?
Also, I got a new vac pump - but didn't want to pull the new pulley just to install the serp. plate (holding in picture below) - will omitting this plate lead to serp. belt issues?
Thanks,
hex
I'm swapping a 94 F350 IDIT into a 88 E350.
The PS pumps are different, and the newer motor is a serp. belt system. I was going to move the serp. pulley over to the old pump - as I have the correct PS lines for that pump and their length is for the '88 chassis. Unfortunately, the serp. pulley shaft diameter is smaller than the old pump shaft. The pressure line for the old PS pump isn't the same thread as the 94 PS pump (too small).
Should I just buy the 1994 F350 PS pressure line and not worry about the extra length? Is there a thread adaptor that is supposed to go into the PS pump housing?
Also, I got a new vac pump - but didn't want to pull the new pulley just to install the serp. plate (holding in picture below) - will omitting this plate lead to serp. belt issues?
Thanks,
hex
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach